Workbench Wednesday

M-K-T boxcar conversion, pt 2

Bill Welch, the Xxtreme Modeler, shared more images of his M-K-T boxcar project. Here’s Bill with a few notes.

Better door rollers were created by harvesting these small pieces from a Tichy Youngstown door set, part #3055. The locking levers were made from 0.015-inch diameter wire that was heated and flattened.

Small details can add to the look of a model. Grain clips were made from small rectangles of thin styrene and glued into place. A defect card holder and towing loops were also installed. Rivets were harvested from an old Athearn boxcar kit and installed where the bolster and cross bearers connect to the side sill. Gussets and diagonal braces on the original car body have been carved off.


Placard boards need to be installed on the car ends and doors. These are easy to build with some styrene and replace kit parts that are often too thick with exaggerated space between boards.


Here’s a view of the right side of the car. The new prototype appropriate details are easy to spot and have improved the model appearance.

Here’s the link to Bill’s previous post on this M-K-T boxcar project. He promises to share more soon.

What’s on your workbench?